ACTIVATOR is used where increased cure speed of HiGlue cyanoacrykate products is required.
| Liquid Properties | |
| Chemical type | Organis Acclerator |
| Appearance | Clear,Amber |
| Specific Gravity@25℃ | 0.68 |
| Viscosity @20℃. mPa.s | 0.4 |
| Flash point (TCC),℃, | -22 (HIGHLY FLAMMABLE) |
| Drying time 20℃ seconds | <30 |
Fixture time and cure speed achieved asresuit of using ACTIVATOR depend on theadhesiveused and the substraate bonded.
Special care must be taken to avoid contace of the activator or its vapor with naked flame or any electrical equipment that's not flame proofed.
The carrying solvent can affect certain plastics or coatings. It is recommended to check all surfaces for compatibility before use.
Avoid prolonged or repeated skin contact.
Use only in a well vetilated area.
No smoking in presence of activator
1. Apply OLIVIA cyanoacryiate to one of thepan to be bonded or fixed.
2. Apply activator to the other part by
3. Apply the oLIvIA cyanoacrylate pro immediately.
Contaminated surfaces may need special cleaning or degreasing prior to activation to remove any dissolvable aontamination.
It is recommended to wear rubber or plastic gloves.
In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
After contact with skin, wash immediately with plenty of water and soap.
Do not store near oxidizing agents or combustble metatials. The activator is light sensitive should be kept in a dark place when not in use.
Products shall be ideally storeed in a cool and dry place at a temperature between10℃to25℃
| Chemical Type ethyl-2cyanoacrylate |
| Appearance Clear, colourless |
| Flashpoint 81℃ |
| Density 1.05 |
| Shelf Life 12months, unopened |
| Viscosity (Brookfield)@25℃ 1200-1800CP |
| Cure Speed |
| Balsa/Balsa <10 Seconds |
| Oak/Oak 120-180 |
| Nitrile/Nitrile 5 Seconds |
| Neoprene/Neoprene <7 Seconds |
| EPDM/EPDM <7 Seconds |
| Steel/Steel 10-20 Seconds |
| PVC/PVC 5-10 Seconds |
| Polycarbonate/Polycaybonate 10-40 Seconds |
| Shear Strength |
| Grit Blasted Steel >15N/mm² |
| Etched Aluminium >11N/mm² |
| Nitrile Rubber >10N/mm² |
| Polycarbonate >12N/mm² |
| Tensile strength |
| Grit Blasted Steel >18N/mm² |
| Nitrile Rubber >5N/mm² |
| Neoprene Rubber >5N/mm² |
| EPDM Rubber >2.5N/mm² |